Fourth project in the diary: a preamplifier built around the type 226 tube. This is the oldest glass in the diary by far.
The tube
The UX-226 — also marked 26, and by Cunningham as CX-326 — was announced in September 1927 by RCA/Westinghouse. It is a directly heated triode: the filament is the cathode. Data (Radiomuseum): filament 1.5 V at 1.05 A, 4-pin UX base, medium-mu triode first used in the RF and audio stages of AC radios like the Radiola 17. From RCA’s published curves, modern designers use a plate resistance of about 7 kΩ and a typical line-stage operating point around 5 mA, 114 V on the plate, −6.85 V grid bias.
Why builders love it
Because it is a DHT. No cathode, no cathode bypass sound — builders on diyAudio’s giant “#26 pre amp” thread (230+ pages) call the 26 one of the best-sounding DHTs for a preamp, and the whole game is making it dead quiet, even into 104 dB horns.
The design problems (and the known answers)
- Filament supply is the whole battle: the filament is the cathode, so AC heating hums straight into the signal. The consensus answer is a regulated DC filament supply — Rod Coleman regulators are the community standard; some builders even starve the filament slightly (800 mA instead of 1.05 A) to cut microphonics and distortion.
- Filament bias: derive the bias from the filament current through a resistor, and the cathode bypass capacitor disappears from the circuit.
- Plate loading, three ways: an output transformer (Lundahl LL2745 wired 5.6:1 step-down — low gain, low output impedance), a plate choke (keep it away from power transformers or it picks up hum), or a solid-state gyrator/CCS load (Bartola’s approach, output impedance around 734 Ω in one version).
- Power supply: a quiet shunt-regulated HT around 200 V (Salas SSHV2 is popular).
- Grounding: separate star points for input, filament-bias return and output, so filament current never shares a path with signal.
Designs to study
- Bartola Valves (Ale Moglia), 26 DHT preamp Generations 1–3: https://www.bartola.co.uk/valves/2013/10/
- diyAudio “#26 pre amp” thread: https://www.diyaudio.com/community/threads/26-pre-amp.151421/
- Radiomuseum UX226 page: https://www.radiomuseum.org/tubes/tube_ux226.html
My own 226 preamp’s circuit choices and photos will be added here as the build diary starts.
— Eric