CV-345 Single Ended — What Is a CV345? (Web Research)

Posted by:

|

On:

|

,

Third project in the diary: a single-ended amplifier built around the CV345. First question: what is a CV345?

The tube

CV stands for “Common Valve” — the British military numbering system, not “Commonwealth Valve”. CV345 is the military number for the 12E1, a beam tetrode introduced in 1946. It was designed as a series-pass valve for stabilised power supplies — the tube that sits in a regulated supply and soaks up voltage. Key data (Valve Museum): heater 6.3 V at 1.6 A, anode maximum 800 V, screen maximum 300 V, International Octal base with the anode brought out to a top cap. Audio Note even uses the CV345/12E1 in the power supply of its M10 preamplifier — its designed job.

Using it single-ended for audio

DIY builders do run the 12E1 as a single-ended output tube. One documented diyAudio build runs it at 300 V and about 85 mA into a 2.5 kΩ output transformer, driven by an EF37/6SN7 stage. The warnings from builders who have done it:

  • It likes to oscillate — fit grid and screen stoppers (120 Ω reported).
  • It hates fixed bias — pass tubes can run away thermally (one builder measured over 100 mA and climbing). The consensus: use cathode (automatic) bias.
  • It needs much more negative grid voltage than KT88-class tubes.

One thing to check on my tubes

“345” without the CV prefix is a different animal — type 345 is a variant of the type 45 directly-heated triode. If my tubes turn out to be globe DHTs, this page gets rewritten. The check is the tube itself: a 12E1 has an octal base and a top cap; a 45-family tube is a 4-pin DHT. I will confirm from the markings and update this entry.

Sources

— Eric