Scott 222A — The Complete Story (Web Research)

Posted by:

|

On:

|

,

Second project in the diary: the H.H. Scott 222A. Here is what the web knows about it.

What it is

A stereo integrated amplifier from H.H. Scott Inc. of Maynard, Massachusetts, made in 1959–1960. Scott’s own 1959 ad calls it the “new H.H. Scott 24 watt stereophonic amplifier, Model 222” and lists it at $139.95. Power ratings need care: Scott published 12 W per channel; later compilations say about 13 W RMS, and one restorer’s chart says 15 W — different period rating conventions, not three different amplifiers. On this page I quote Scott’s own 12 W figure.

The circuit

11 tubes: 4× 12AX7 (phono preamp and line/tone stages), 2× 6BL8 (driver + floating paraphase phase inverter, one per channel — Scott restorers note the A model was designed around the 6BL8), 4× 6BQ5/EL84 in push-pull (self-biased / cathode bias, no factory bias adjustment), and 1× 5AR4/GZ34 rectifier. Output transformer TRA 7-1, power transformer TR-12-7. The preamp heaters run on DC for low hum.

Scott’s published specifications (1959)

  • Power: 12 W per channel
  • IM distortion: 0.3%
  • Harmonic distortion: 0.8%
  • Frequency response: 20 to 30,000 Hz
  • Hum level: −80 dB
  • Phono sensitivity: 3 mV

Controls

Separate bass and treble controls for each channel, a stereo selector with seven modes, balance, volume with loudness function, a scratch filter, and a center-channel output. Inputs: one magnetic phono and two high-level inputs. (Speaker taps of 4/8/16 Ω are the 222-family norm; I could not verify the 222A’s own tap list from a factory source.)

What restorers say today

The big one: this family uses a selenium rectifier for the DC preamp-heater supply, and it always fails with age — replace it with silicon plus a dropping resistor. Also the three multi-section can electrolytics, leaky coupling capacitors, drifted carbon resistors, dirty sockets and pots, and a CL-80 inrush thermistor to tame modern line voltage. A common upgrade is adding per-channel bias adjustment and test points, since the stock amp has none. Restored 222-family amps are praised for their phono stage, imaging and bass. Asking prices for restored 222C/D units run roughly $650–$1,100 (I found no verified 222A-specific sale — the A is the rarest of the family).

Schematic and further reading

My 222A’s own photos and first notes will be added here as the diary goes.
— Eric