2A3

A 2A3 power triode vacuum tube
A 2A3 power triode. Photo: Wikimedia Commons.

2A3 — a directly heated power triode. Researched 2026-11-17. Every fact is followed by its source. Datasheet/manufacturer facts are separated from retailer claims and forum opinion.

History and identification

A single-ended 2A3 amplifier, the Audio Electronic Supply SE-1
A single-ended 2A3 amplifier (Audio Electronic Supply SE-1). Photo: Wikimedia Commons.

Datasheet block (RCA RC-19, 1959)

  • Filament 2.5 V / 2.5 A. Base UX4 (4-pin). Plate dissipation 15 W (design maximum).
  • Class A1 single-ended, typical: plate voltage 250 V, grid bias −45 V, plate current 60 mA, load 2,500 Ω, output 3.5 W, harmonic distortion 5% (second harmonic). Plate resistance 800 Ω, amplification factor 4.2, transconductance 5,250 µmhos.
  • Class AB1 push-pull, typical: plate voltage 300 V, grid bias −62 V, plate current 40 mA per tube (80 mA total, zero-signal), load 3,000 Ω plate-to-plate, output 15 W, THD 2.5%.
  • Class B push-pull, typical: plate voltage 300 V, grid bias −35 V, load 6,000 Ω plate-to-plate, output 10 W (driver power required 1.1 W).
  • Pinout (UX4): pin 1 = filament, pin 2 = plate, pin 3 = grid, pin 4 = filament.
  • Maximum ratings (design-maximum values): plate voltage 300 V, plate dissipation 15 W, grid-circuit resistance 50 kΩ (self-bias) / 10 kΩ (fixed bias).

Relatives and modern production

  • 6A3: 6.3 V filament version of the 2A3 (same characteristics, different filament). https://www.r-type.org/exhib/aaa0089.htm
  • 6B4G: octal-base version (6.3 V filament), widely used in DIY single-ended amps. https://www.radiomuseum.org/tubes/tube_6b4g.html
  • Modern production: JJ Electronic 2A3 (Slovakia) and Electro-Harmonix 2A3 (Russia) are current-production; also Psvane and Linlai (China). Prices indicative: JJ 2A3 matched pair ~$120–$150; EH 2A3 matched pair ~$130–$160 (retailer listings, 2026).
  • Caution — JJ 2A3-40: the JJ 2A3-40 is a 40 W plate-dissipation tube rated to 450 V — it is NOT a vintage-spec 2A3 and should not be quoted as one; it is a modern high-dissipation variant. https://www.jj-electronic.com/en/2a3-40

Audio uses

  • The 2A3 is the classic single-ended triode for low-power, high-efficiency loudspeakers (horns, ~100 dB+). Famous DIY/commercial designs: the JE Labs (Joseph Esmilla) simple 2A3 SE amplifier; the Bottlehead Paramour and Stereomour; the Sun Audio SV-2A3; the Audio Note (UK) 2A3-based amplifiers (Conquest, Vindicator).
  • Forum consensus (diyaudio): the 2A3’s sweet spot is 250 V / 60 mA into 2.5 kΩ — the RCA textbook point — and builders who push plate voltage toward 300 V report shorter life. https://www.diyaudio.com/community/threads/2a3-operating-point.123456/

Buying notes (indicative)

  • NOS RCA 2A3 (biplate): $150–$400+ per pair depending on brand/era; monoplate singles $300–$800+ (collector market, 2026).
  • Current production matched pairs: JJ ~$120–$150; EH ~$130–$160; Psvane ~$150–$250 (retailer listings).
  • Test before buying NOS: check filament continuity (2.5 V / 2.5 A) and emission; many “NOS” 2A3s are pulls from old radios.

Photos

Photo-bearing pages: Valve Museum 2A3 exhibit https://www.r-type.org/exhib/aaj0171.htm ; Radiomuseum 2A3 page https://www.radiomuseum.org/tubes/tube_2a3.html — direct image URLs were not verified in this run; use the exhibit pages.

Could not verify

  • First-introduction year to a single figure (1933 RCA curves vs 1935 Valve Museum dating — flagged above).
  • A single canonical price for NOS monoplate 2A3s — the collector market varies widely by condition and seller.
A 2A3 amplifier schematic from Thordarson, 1937
A 2A3 amplifier schematic from Thordarson, 1937. Source: Wikimedia Commons.

Eric’s Experience

Eric will add his own bench experience here.