
6U8A / 6U8 (= ECF82) — a triode-pentode for television and audio use. Researched 2026-11-17. Every fact is followed by its source. Datasheet/manufacturer facts are separated from retailer claims and forum opinion.
What it is (museum + manufacturer)
- r-type 6U8 page: triode-pentode from 1954; “6U8 is the American designation and ECF82 would be the Mullard type designation if the two were exactly identical. In ECF82 Mullard put both designations on the envelope indicating equivalence”; sensibly equivalent to 6TP1, CV5065, ECF82; design purpose VHF radio/TV 80–220 MHz (Bands II–III), used as a mixer with the triode as local oscillator; envelope 20 mm × 47 mm excl. B9A pins. https://www.r-type.org/exhib/aaa1219.htm
- r-type ECF82 page: “high slope triode pentode designed for television use as a frequency changer or mixer. It was also found to be effective as an audio phase splitter”; first introduced 1953. http://www.r-type.org/exhib/aaa1168.htm
- r-type 6U8A page: “differs from the 6U8 mainly in the fact that the heating time is tightly controlled”; constructed as a beam tetrode though designated triode-pentode; used in many colour TV chassis; triode is medium-μ, pentode sharp cut-off; envelope 20 mm × 51 mm. http://www.r-type.org/exhib/aaa1389.htm
- Tung-Sol 6U8 datasheet (1962, manufacturer): “combines two electrically independent sections — a triode and a pentode — in the 9-pin miniature construction… may be used as a local oscillator-pentode mixer in FM or television receivers”; “The 6U8A curves also apply for the 6U8” (i.e. the A version is the controlled-warm-up variant only). https://w140.com/tekwiki/images/d/d3/Tung-Sol_6U8_data_sheet.pdf
Datasheet block (both sections)
- Heater 6.3 V / 450 mA (Tung-Sol; base E9-1 / JEDEC 6-2). Note: one marketplace listing for Telefunken ECF82 prints “6.3 V / 0.3 A” — inconsistent with Tung-Sol’s 450 mA; treat 0.45 A as authoritative. https://picclick.co.uk/6U8A-NOS-vacuum-tube-CBS-triode-pentode-186273380839.html
- Pinout (B9A, r-type, both 6U8 and 6U8A pages): 1=a(t) triode plate, 2=g1 pentode, 3=g2 pentode, 4=h, 5=h, 6=a pentode plate, 7=k/g3/shield pentode cathode, 8=k(t) triode cathode, 9=g1(t) triode grid. URLs above. (A Heathkit EC-1 cheatsheet page found in search results gives a conflicting mapping — inconsistent with r-type/Tung-Sol; ignore it.)
- Design maximum (Tung-Sol): pentode plate voltage 330 V, triode plate voltage 330 V, pentode plate dissipation 3.0 W.
- Typical characteristics (fourwater compilation of datasheet values): pentode at Va 125 V, Vg2 110 V, Vg1 −1.0 V: Ia 9.5 mA, Ig2 3.5 mA, rp 200 kΩ, gm 5,000 µmhos; triode at Va 125 V, Vg1 −1.0 V: Ia 13.5 mA, gm 7,500 µmhos, mu 40; max Vp 330 V both sections. http://www.fourwater.com/files/triodepentode.txt — Tung-Sol’s sheet lists the same two transconductances (7,500 and 5,000 µmhos).
- Independent seller test data (Tungsram ECF82 listing, measured at catalogue parameters): triode Ua 150 V / Ug1 −1 V: 100% = Ia 18 mA, S 8.5 mA/V; pentode Ua 170 V / Ug2 110 V / Ug1 −1.0 V: 100% = Ia 10 mA, S 5.2 mA/V. https://picclick.com/Ecf82-Tungsram-Triode-Pentode-Vacuum-Tube-Nos-6U8-275153353630.html
- Flag: r-type’s table prints a gm of “1.9” — inconsistent with every other source (5,000 µmhos pentode); treat as an r-type table/OCR error. Forum-compiled tables (Audio Asylum) also swap the triode/pentode gm assignments in places — Tung-Sol/fourwater (triode 7,500, pentode 5,000 µmhos) is the consistent reading.
Equivalents and relatives — with substitution cautions
- ECF82 = 6U8 verified (r-type + Mullard dual-marking, above). Also 6TP1, CV5065; retailer lists add 6678, 6AX8, 6KD8, 6F2. https://www.tubeampdoctor.com/en/6u8a/ecf82-nos-usa-jan-philips ; special-quality 6678 = a 6U8 variant (fourwater, above).
- 6GH8/6GH8A are relatives, NOT identical types — different ratings (forum-compiled bogey figures citing GE/RCA/Tung-Sol sheets: 6GH8 pentode gm ~8,500 µmhos vs 6U8’s lower figure; triode mu ~46 for 6GH8A vs 40 for 6U8) and r-type’s statement that “the 6U8A can be used to replace 6GH8 or 6EA8” should not be read as blanket interchangeability. https://www.audioasylum.com/messages/tubes/197058/6u8a-6gh8a-6bl8-and-7199 ; http://www.r-type.org/exhib/aaa1389.htm — McIntosh MR67 tuner designer Modaferri is reported (forum) to recommend 6GH8A in place of 6U8A in his designs (Audio Asylum, same thread).
- 7199 relationship (key caution): the 7199 is a triode-pentode designed specifically for audio (1959) — pentode input + triode phase splitter — used in the Dynaco ST-70, one per channel. It has no direct equivalent: 6U8/6U8A can substitute only with changes to base wiring or an adapter, because the pinout differs. http://www.r-type.org/exhib/acf0103.htm ; https://en.wikipedia.org/wiki/7199 ; https://watfordvalves.com/product_detail.asp?ID=377 — Stability caution (Gillespie Designs): their PC-10A board for the Dynaco SCA-35/ST-35 “replaces the obsolete… 7199 driver tube with either a 6GH8A or 6U8A. Note that this is not just a tube swap. Additional components have been added to prevent stability issues that can occur when these tubes are simply used with adapter sockets in the original PC-10 board.” http://www.audioregenesis.com/ ; GetDynaco likewise warns their 6GH8A/6U8A driver tubes are “not a replacement for a 7199 tube” without the updated board or proper adapters. https://www.getdynaco.com/vacuum-tubes/st-70-mk-iv-tubes
Audio uses
- Scott: the HH Scott database lists 6U8/6GH8 as driver/phase-inverter tubes across the 222-B, 222-C, 222-D, 233, 299(A), 299-B and 299-D families (variously “6U8 or 6GH8,” and “6U8 or 7199” on some 299-B/C entries — Scott swapped types between production runs). http://akdatabase.com/AKview/albums/userpics/10007/HHScott%20Gallery%20–%20Stereo%20Integrated%20Amplifiers.pdf
- VTV Issue 13 (Scott 222/LK-48 article): “6BL8/6U8 driver/phase inverter tubes were effective…”; early 222C used a 6GH8 inverter/driver, later changed to 7199; LK-48 = kit 222C, LK-48B = kit 222D; 222C/D output B+ raised to 420 V with 7189 outputs. https://www.worldradiohistory.com/hd2/IDX-Audio/Vacuum-Tube-Valley-IDX/IDX/Vacuum-Tube-Valley-13-OCR-Page-0016.pdf
- VTV Issue 12 (Scott 299 article): TV-derived triode-pentodes (6GH8, 6BL8/ECF80, 6U8, 6EA8) “eventually found their way into audio applications in the mid-1950s in Dynaco, Fisher, McIntosh, etc.”; Scott used ECF80/6BL8 in the original 299 driver/phase-inverter. https://www.worldradiohistory.com/hd2/IDX-Audio/Vacuum-Tube-Valley-IDX/IDX/Vacuum-Tube-Valley-12-OCR-Page-0020.pdf
- Concrete units: a restored Scott 222D with “Pair of Telefunken 6U8-A” https://reverb.com/item/86163194-hh-scott-222d-integrated-tube-amplifier-excellent-restored-condition-orig-box ; a Scott LK-48/222D listing: “2 – 6U8A for the output tube driver stage and 4 – 7189 output tubes.” https://www.canuckaudiomart.com/details/649927817-h-h-scott-lk-48-222d-integrated-vacuum-tube-amplifier/
- Dynaco: stock Dynaco amps used the 7199, NOT the 6U8A — the 6U8A enters Dynaco service only via adapter or redesigned driver boards (Gillespie PC-10A; Dynakit-style ST-70 boards using 6GH8A/6EA8/6U8A). A rebuilt SCA-35 listing notes “6U8A tubes were also used by famous amp makers like H.H. Scott for exactly the same purpose (phase splitter/inverter).” https://reverb.com/item/19713241-rebuilt-vintage-dynaco-sca-35-stereo-tube-amplifier-integrated-preamp-phono
- Forum: Scott 299C owners confirm 6U8 and 6U8A are interchangeable in that socket. https://db.audioasylum.com/cgi/search.mpl?forum=tubes&searchtext=6u8
- Non-audio notable use: the Heathkit EC-1 analog computer used nine 6U8/6U8A as DC op-amp modules (pentode gain stage + triode follower per envelope). https://heathkit.fubsypoly.com/ec-1-analog-computer/vol-2/
Buying notes (indicative — cheap and plentiful)
- Watford Valves: Philips ECG JAN ECF82/6U8A £10.00, in stock (fetched live). https://www.watfordvalves.com/products.asp?ID=1&man=25
- Tube Amp Doctor: JAN Philips 6U8A/ECF82 NOS €21.98. https://www.tubeampdoctor.com/en/6u8a/ecf82-nos-usa-jan-philips
- eBay/PicClick NOS singles mostly $4.95–$9.98 (RCA NOS NIB $6.49; Westinghouse $9.98; Sylvania $7.88); JAN singles to $19.88; matched pairs $19.95–$32.95; premium Telefunken ECF82 singles £20–£59. https://picclick.com/RCA-6U8A-Vacuum-Tube-NOS-NIB-Tested-Hickok-278383007128.html ; https://picclick.co.uk/6U8A-NOS-vacuum-tube-CBS-triode-pentode-186273380839.html
Photos (verified direct URLs)
- https://www.tubeampdoctor.com/media/image/dd/47/fa/S6U8-6U8-6U8A-ECF82-NOS-1_200x200@2x.jpg — JAN Philips 6U8A. Product page: https://www.tubeampdoctor.com/en/6u8a/ecf82-nos-usa-jan-philips (tubeampdoctor.com; image extracted from the TAD NOS category listing fetched live 2026-11-17).
- https://www.watfordvalves.com/images/products/thumbs/1/0010_valve_181004.jpg — Philips ECG JAN ECF82/6U8A (the image attached to that product row). Page: https://www.watfordvalves.com/products.asp?ID=1&man=25 (watfordvalves.com, fetched live 2026-11-17).
Could not verify
- A single authoritative triode-section dissipation figure (Tung-Sol snippet verified only the pentode’s 3.0 W; a forum compilation gives triode 3 W / pentode 2.5 W, conflicting with Tung-Sol).
- Whether any stock Dynaco model ever shipped with 6U8A — all evidence says no (7199 stock; 6U8A only via mods/adapters).
- r-type’s gm “1.9” table entry (flagged above as an apparent error).
Eric’s Experience
Eric will add his own bench experience here.