Category: Heathkit SA-2
-
Heathkit SA-2 — The Complete Story (Web Research)
Before I took mine apart, I went looking for everything the web knows about the Heathkit SA-2. Here is the summary. What it is The SA-2 is a stereo integrated amplifier/preamplifier kit from the Heath Company of Benton Harbor, Michigan. It was advertised as new in January 1960 at a kit price of $52.95. In… Read more
-
SA-2 Reference — The factory schematic
Added the factory schematic to the project file — this is the reference for everything in this diary. The whole amp on one page: 12AX7 phono/input stages, 6AU6 pentodes (V3/V4), the 6AN8 driver (V5/V6) and EL84 push-pull outputs, GZ34/5AR4 rectifier. The numbers that matter for the driver work: Heathkit’s voltage chart shows the 6AN8 pentode… Read more
-
SA-2 Diary 3 — The corrected pick: 180k plate, target pin 6 at 92–110V
Working the numbers again for 300V B+: keep the 470k ohm screen resistor, change the plate resistor to 180k ohm. Expected result: about 111V at pin 6 (the pentode plate / triode grid), right at the top of the 92–110V target window. Screen bypass capacitor for the 470k screen resistor: 2.2–4.7 uF, rated for full… Read more
-
SA-2 Diary 2 — First change: 100k plate / 470k screen
Changed the 6AN8 pentode resistors to 100k ohm plate and 470k ohm screen to bring the plate up. It worked — too well. At the SA-2’s actual driver B+ of 300V, the plate now looks to land around 180–195V, well above the roughly 92–110V window the cathodyne triode wants at its grid. The splitter gets… Read more
-
SA-2 Diary 1 — Starting point: the original 6AN8 driver values
The SA-2 came with the stock Heathkit driver values for the 6AN8 pentode section: 220k ohm plate resistor and 680k ohm screen resistor. Problem: the pentode plate voltage sits too low. Because the pentode plate is direct-coupled to the triode cathodyne splitter’s grid, a low plate voltage starves the splitter. First entry in the diary… Read more