
Added the factory schematic to the project file — this is the reference for everything in this diary. The whole amp on one page: 12AX7 phono/input stages, 6AU6 pentodes (V3/V4), the 6AN8 driver (V5/V6) and EL84 push-pull outputs, GZ34/5AR4 rectifier.
The numbers that matter for the driver work: Heathkit’s voltage chart shows the 6AN8 pentode plate (pin 6) at 90V with the stock 220k plate / 680k screen resistors, screen at 70V, cathode at 1.6V. The triode splitter runs grid 90V, cathode 95V, plate 235V. Readings were taken at 117V AC line and Heathkit allows ±10%, so on today’s line voltage expect everything a little higher.
That puts the factory pin 6 right at the bottom of the 92–110V target window in Diary 3 — a good sanity check. The next measurement (pin 6 with the 100k resistor still in) gets compared against this 90V factory figure too.